medium10 pts · first answer countsfirmwareoscilloscopehardware-debugging
Ringing seen on the scope
A 3.3 V clock edge shows 1.5 V of overshoot and ringing on the oscilloscope, but the board works fine. The probe uses its 15 cm ground clip. What should you try first?
Discussion 0
Join free to post in the discussion.
Related questions
- Choosing scope or logic analyserEmbedded Systems Engineer
- First words read after resetEmbedded Systems Engineer
- Why registers are volatileEmbedded Systems Engineer
- Value of an uninitialised globalEmbedded Systems Engineer
- Where initialised globals come fromEmbedded Systems Engineer
- Signals used by SWDEmbedded Systems Engineer
- Garbage characters on the consoleEmbedded Systems Engineer
- I2C lines sitting at 0 VEmbedded Systems Engineer